Step 4 Basic Phone Configuration
Mon, 20 Jun 2016 | IP Telephony
From global configuration mode, use the tftp-server flash P003XXXX.XXX command to allow the firmware files to be accessed through the TFTP server service running on the router. An example of this command is as follows tftp-server flash P00303020214.bin CMERouterX(config) tftp-server flash P003XXXXXXXX.XXX Note The filename typed after the flash parameter is case-sensitive. Repeat this command for all P003 firmware files present in Flash memory. b. From global configuration mode, enter...
- Equipment Requirements - 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19
- MAC Address
- Step 1 Add a Second IP Phone by using the Auto Assign Method
- Step 1 Configure a Phone using the GUI for the Phone User
- Step 1 Configure a Phone using the GUI interface for the Customer Administrator
- Step 1 Configure Call Transfer and Call Forward - 2
- Step 1 Configure Class of Restriction
- Step 1 Configure paging groups
- Step 1 Configure the dialable intercom
- Step 1 Configure the FXO Port
- Step 1 Configure the GUI interface for the System Administrator
- Step 1 Configure the Serial Interface
- Step 1 Configure the TFTP server
- Step 1 Customize the IP Phone Display
- Step 1 Locate the T1 Port on the CME Router
- Step 1 Understanding the two types of switches
- Step 1 Verify Connectivity and IP Phones
- Step 1 Verify FXS interface
- Step 1 Verify if the Telephony Service is Running
- Step 12 Configure the switch port as a trunk port
- Step 13 Test connectivity across the trunk
- Step 15 Configure switch ports for IP phones
- Step 2 Apply Class of Restriction to a Dial Peer
- Step 2 Basic CME Router Configuration
- Step 2 Cabling the IP phone to an inline power switch
- Step 2 Configure DHCP for the IP Phones
- Step 2 Configure the Dial Peer - 2
- Step 2 Configure the GUI interface for the System Administrator
- Step 2 Configuring AutoQoS on Cisco IOS Routers
- Step 2 Confirm Correct Setup of CME
- Step 2 Connect an IP Phone
- Step 2 Connect Analog Phone
- Step 2 Examining Call Forward Features
- Step 2 Reset the Cisco IP phone
- Step 2 Test the Intercom Configuration
- Step 2 Update and Install Cisco Call Manager Express IOS
- Step 3 Basic CME Router Configuration
- Step 3 Cabling the IP phone to a noninline power switch
- Step 3 Configure the T1 Controller
- Step 3 Erasing the CME Switch
- Step 3 Review Changes to the Running Configuration
- Step 3 Test the Configuration
- Step 3 Test the New Account
- Step 3 Verify and Configure Firmware
- Step 4 Configure system time using the GUI
- Step 4 Configure the Dial Peer to Call the Analog Phone
- Step 4 Configure the Router Switch Ports
- Step 4 Connect a PC to the IP phone port
- Step 4 Download XML Template
- Step 4 Examine the current switch configuration
- Step 4 Reconfigure the Codec
- Step 5 Configure the Dial Peer to Call from the analog phone on the Adtran
- Step 5 Verify Phone Registration
- Step 5 Verify VLAN Configuration
- Step 9 Configure Layer 3 access to the switch
- Student Lab Manual
- TCP and UDP Port Numbers