Cisco Certified ExpertCommunications Server 0 Points
NOTE Not all CCIE R&S labs require you to configure a communications server.
Configure the communications server so that when you type the host name of a router on the server, you are connected across the console port to that router. Set up the routers in Figure D-1 with the following physical attributes:
1. Configure R1 as the communication server with the ip host command.
2. Communication server ports 2 to 4 are connected to Routers R2 to R4, respectively.
3. Communication server port 9 connects to the Catalyst 3550 Ethernet switch.
Was this article helpful?
Post a comment