Example 533 hosta Cable Disconnect SecureCRT Output

r1#clear counters ethernet 0

Clear "show interface" counters on this interface [confirm]

00:25:45: %CLEAR-5-COUNTERS: Clear counter on interface Ethernet0 by console

r1# debug arp

ARP packet debugging is on

00:26:07: IP ARP: rcvd req src 192.168.5.18 0010.4ba5.ae50,

dst 192.168.5.19 Ethernet0

r1#show interface ethernet 0

Ethernet0 is up, line protocol is up

Hardware is Lance, address is 0000.0c8d.6705 (bia 0000.0c8d.

6705)

Description: r1e0 to hosta hostb and gwise

Internet address is 192.168.5.17/28

r1#!!!this is when I plugged the cable back in

r1#show interface ethernet 0

Ethernet0 is up, line protocol is up

Hardware is Lance, address is 0000.0c8d.6705 (bia 0000.0c8d.

6705)

Description: r1e0 to hosta hostb and gwise

Internet address is 192.168.5.17/28

MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255,

load 1/255

Encapsulation ARPA, loopback not set, keepalive set (10 sec)

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:02, output hang never

Last clearing of "show interface" counters 00:01:33

Queueing strategy: fifo

00:27:17: IP ARP: rcvd req src 192.168.5.18 0010.4ba5.ae50,

dst 192.168.5.18 Ethernet0

00:27:17: IP ARP: rcvd req src 192.168.5.18 0010.4ba5.ae50,

dst 192.168.5.19 Ethernet0

00:27:17: IP ARP: rcvd req src 192.168.5.18 0010.4ba5.ae50,

If you analyzed the ARP table on the host with arp -a, you should have the MAC addresses and IP add resses fo r h osta and hostb.

0 0

Post a comment