HSRP Status

To display the status of the HSRP router, enter the following command in privileged EXEC mode.

Router#show standby type-number group brief The command options for this command are defined as follows:

• type-number—This optional argument indicates the target interface type and number for which output is displayed.

• group—This optional argument indicates a specific HSRP group on the interface for which output is displayed.

• brief—This option displays a single line of output summarizing each standby group.

If these optional interface parameters are not indicated, the show standby command displays HSRP information for all interfaces. Example 9-5 presents the output resulting when the type-number and group parameters are specified.

Example 9-5 show standby Command Output with type-number and group Parameters Specified

Router#show standby Vlan100 50

Vlan100 - Group 50

Local state is Active, priority 150, may preempt

Hellotime 3 holdtime 10

Next hello sent in 00:00:02.944

Hot standby IP address is 192.168.100.50 configured Active router is local

Standby router is 192.168.100.1 expires in 00:00:08 Standby virtual mac address is 0000.0d05.ab10 Tracking interface states for 1 interface, 1 up: Up Vlan51 Priority decrement: 40

Example 9-6 demonstrates output resulting when the brief parameter is specified. Example 9-6 show standby brief Command Output

Router#show standby brief

Interface Grp Prio P State

Active addr

Standby

addr

Group

addr

Vl00 50 160 P Active

local

192.168

100.1

192.168

100.50

Vl12 12 100 Standby

192.168.102.1

local

192.168

12.10

0 0

Post a comment