Physical Layout and Prestaging

• Connect the hubs and serial cables to the routers, as shown in Figure 11-13.

• The stillwater router will run RIP only on network 172.16.0.0. Configure this router at this time. See Chapter 9 if you need assistance on this.

• A Frame Relay switch with three PVCs also is required. Example 11-31 lists the Frame Relay configuration used in this lab.

Example 11-31 Frame Relay Switch Configuration hostname frame_switch

frame-relay switching

interface Serial0 no ip address encapsulation frame-relay no fair-queue clockrate 148000 frame-relay intf-type dce frame-relay route 111 interface Serial1 110 frame-relay route 121 interface Serial3 102 frame-relay route 150 interface Serial5 151

interface Serial1 no ip address encapsulation frame-relay clockrate 148000 frame-relay intf-type dce frame-relay route 110 interface Serial0 111

interface Serial3

Example 11-31 Frame Relay Switch Configuration (Continued)

no ip address encapsulation frame-relay clockrate 64000

frame-relay intf-type dce frame-relay route 102 interface Serial0 121

interface Serial5 no ip address encapsulation frame-relay clockrate 64000 frame-relay intf-type dce frame-relay route 151 interface Serial0 150

Figure 11-13 Cisco Training Partners Network

Cisco Training Partners Network

S0.1 Multipoint IP=192.168.1.1/29

S0.2 point-to-point IP=192.168.2.1/24

EIGRP AS 65001

EIGRP Stub georgia

S0.1 Multipoint IP=192.168.1.1/29

S0.2 point-to-point IP=192.168.2.1/24

EIGRP AS 65001

EIGRP Stub georgia

Was this article helpful?

0 0

Post a comment