Example 1813 show dotlx all Command Output

Switch#sho dotlx all

Dotlx Info for interface FastEthernet0/3

Supplicant MAC 0040

AuthSM State BendSM State PortStatus MaxReq HostMode Port Control QuietPeriod Re-authentication ReAuthPeriod ServerTimeout SuppTimeout TxPeriod Guest-Vlan = 0

4513.075b AUTHENTICATED

: IDLE AUTHORIZED

Single Auto : 60 Seconds Enabled l20 Seconds : 30 Seconds : 30 Seconds 30 Seconds

The output provides information on all the 802.1x-enabled ports. Key information that displays includes the MAC address of the client attached to the interface and status of the port and authentication state. If the client has not been authenticated or is in the process of being authenticated, the AuthSM State would be CONNECTING , and the port status would be UNAUTHORIZED . The following shows the output:

Switch# show dotlx all

Dotlx Info for interface FastEthernet0/3

Supplicant MAC <Not Applicable>

AuthSM State = CONNECTING

BendSM State = IDLE

PortStatus = UNAUTHORIZED

MaxReq = 2

HostMode

Port Control

QuietPeriod

Re-authentication

ReAuthPeriod

ServerTimeout

SuppTimeout

TxPeriod

Guest-Vlan

= Single

= 60 Seconds

= Enabled

= 30 Seconds

= 30 Seconds

= 30 Seconds

= 30 Seconds

To display 802.1x information on a specific interface, use the interface interface-id parameter. Example 18-14 provides the output of this parameter on port 10 of a Catalyst switch.

0 0

Post a comment