Adjusting Timers for DHCP

The following example shows how to enable a VLAN as an IEEE 802.1x guest VLAN when an IEEE 802.1x port is connected to a DHCP client. You will set 3 as the quiet time on the switch, and set 15 as the number of seconds that the switch waits for a response to an EAP Request/Identity frame from the client before resending the request.

Switch(config-if)# dot1x timeout quiet-period 3 Switch(config-if)# dot1x timeout tx-period 15

Switch(config-if)# dot1x guest-vlan 20

© 2007 Cisco Systems, Inc. Trust and Identity 2-111

0 0

Post a comment