Configuration Exercises

Refer to Figure 4-28 for Configuration Exercises 1-5. Figure 4-28 The Internetwork for Configuration Exercises 1-5

SVR3

AS 3

172.16.0.0/16 ISP1 block:

201.50.13.0/24

ISP2 block:

200.100.30.0/24

ISP1 in Figure 4-28 has assigned the address block 201.50.13.0/24 to AS 3. ISP2 has assigned the address block 200.100.30.0/24 to AS 3. RTR1 and RTR2 are accepting full BGP routes from the ISP routers but do not transmit any routes to the ISPs. They run IBGP between them and OSPF on all Ethernet interfaces. No routes are redistributed between BGP and OSPF. The addresses of the router interfaces are as follows:

RTR1, E0: 172.16.3.1/24 RTR1, El: 172.16.2.1/24 RTR1, SO: 201.50.26.13/30 RTR2, E0: 172.16.3.2/24 RTR2, El: 172.16.1.1/24 RTR2, SO: 200.100.29.241/30

SVR1 is the DNS server authoritative for AS 3; its address is 172.16.3.3. DNS1 reaches SVR1 at 201.50.13.1, whereas DNS2 reaches the same server at 200.100.30.254. Write routing and NAT configurations for RTR1 and RTR2, translating inside addresses appropriately for each ISP's assigned address block. Any inside device must be able to reach either ISP, but no packets can leave AS 3 with a private source address under any circumstance.

2 The address of SVR2 in Figure 4-28 is 172.16.2.2, and the address of SVR3 is 172.16.2.3. Modify the configurations of Configuration Exercise 1 so that devices within ISPl's AS connect to the servers round-robin at the address 201.50.13.3.

3 HTTP packets sent to 200.100.30.50 from ISP2 are sent to SVR2 in Figure 4-28. SMTP packets sent to 200.100.30.50 from ISP2 are sent to SVR3. Modify the configurations of the previous exercises to implement these translations.

4 Five outside devices in Figure 4-28, 201.50.12.67-201.50.12.71, must appear to devices within AS 3 as having addresses 192.168.1.1-192.168.1.5, respectively. Add the appropriate NAT configurations to the previously created configurations.

5 Devices in AS 3 of Figure 4-28 with addresses in the 172.16.100.0/24 subnet should all appear to have the IG address 200.100.30.75 when sending packets to ISP2. Modify the configurations of the previous exercises to accommodate this.

6 In Figure 4-29, redundant links have been added so that RTR1 and RTR2 each have connections to both ISPs, and each accept full BGP routes from both ISPs. The address of RTR1, SI is 200.100.29.137/30, and the address of RTR2, SI is 201.50.26.93/30. Write configurations for the two routers, ensuring that all features added in the previous exercises still work correctly.

Figure 4-29 The Internetwork for Configuration Exercise 6

Figure 4-29 The Internetwork for Configuration Exercise 6

Was this article helpful?

0 0
100 SEO Tips

100 SEO Tips

100 SEO Tips EVERY SEO Enthusiast Should Know. This Report 100 SEO Tips will help you to Utilize These Tips to Dominate The Search Engine Today.

Get My Free Ebook


Post a comment