Monitoring MLP with Interleaving

This topic describes the Cisco IOS commands that are used to monitor MLP with interleaving.

show interfaces multilink interface-number

• Displays MLP statistics including the number of interleaved frames router>show interfaces multilink 1 Multilink1 is up, line protocol is up Hardware is multilink group interface Internet address is 172.22.13 0.1/30 MTU 1500 bytes, BW 64 Kbit, DLY 100000 usec, reliability 255/255, txload 27/255, rxload 1/255 Encapsulation PPP, loopback not set Keepalive set (10 sec) DTR is pulsed for 2 seconds on reset LCP Open, multilink Open Open: IPCP

Last input 00:00:03, output never, output hang never Last clearing of "show interface" counters 6d00h

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: weighted fair

Output queue: 0/100 0/64/0/2441 (size/max total/threshold/drops/interleaves) Conversations 0/7/16 (active/max active/max total) Reserved Conversations 0/0 (allocated/max allocated) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 7000 bits/sec, 6 packets/sec

The show interfaces multilink command output includes MLP LFI statistics information and indicates whether MLP interleaving is enabled on the interface. Multilink should be in the open state along with Link Control Protocol (LCP) and IP Control Protocol (IPCP).

router>

Was this article helpful?

0 0

Post a comment