Example Configuring the AutoQoS Enterprise Feature on a High Speed Serial Interface

In the example, the AutoQoS Enterprise feature is configured on the high-speed serial interface s1/1:

Router> enable Router# configure terminal Router(config)# interface s1/1 Router(config-if)# bandwidth 1540

Router(config-if)# ip address 10.10.100.1 255.255.255.0 Router(config-if)# auto discovery qos Router(config-if)# auto qos Router(config-if)# exit

This topic describes how to use Cisco IOS commands to examine and monitor a network configuration after AutoQoS has been configured.

When the AutoQoS Enterprise feature is configured on a router WAN interface, you can use the show auto qos command to verify the contents of the interface configurations, policy maps, class maps, and ACLs.

You can use the show auto qos interface command with Frame Relay DLCIs and ATM PVCs. The show auto qos interface [interface type] command displays the configurations created by the AutoQoS VoIP feature on the specified interface.

When the interface keyword is used but an interface type is not specified, the show auto qos interface command displays the configurations created by the AutoQoS Enterprise feature on all the interfaces or PVCs on which the AutoQoS Enterprise feature is enabled.

Was this article helpful?

0 0

Post a comment