Configuring CoSto Queue Mappings for PQ on Catalyst 2950 Switches

This topic describes the commands required to configure CoS-to-queue mappings for PQ on the Cisco Catalyst 2950 switch.

To configure CoS-to-queue mappings for PQ on the Catalyst 2950 switch, specify the queue ID of the CoS priority queue. Ranges are 1 to 4 where 1 is the lowest CoS priority queue. Then, specify the CoS values that are mapped to the queue ID.

wrr-queue cos-map quid cos1...cosn

Syntax Description

Parameter

Descri ption

quid

The queue ID of the CoS priority queue. Ranges are 1 to 4 where 1 is the lowest CoS priority queue.

cosl...cosn

The CoS values that are mapped to the queue ID.

The default CoS-to-priority queue assignments are shown in this table.

Queue

1

2

3

4

CoS Values

0, 1

2, 3

4, 5

6, 7

Was this article helpful?

0 0

Post a comment