Verification

Verify that an OSPF neighbor relationship has been established between Routers A and B. rtrA#show ip ospf neighbor

Neighbor ID Pri State Dead Time Address Interface 2.2.2.2 1 FULL/DR 00:01:53 10.1.1.2 Serial0/0

The neighbor relationship has been established even though the neighbor command was configured on only one end of the link. Why was a Designated Router (DR) elected? OSPF thinks that this point-to-point link is a broadcast network, and DRs are always elected on broadcast networks.

Was this article helpful?

0 0

Post a comment