Table 31 UNI Service Attribute

UNIService Attribute

Parameter Values or Range of Values

Physical medium

A standard Ethernet physical interface.

Speed

10 Mbps, 100 Mbps, 1 Gbps, or 10 Gbps.

Mode

Full-duplex or autospeed negotiation.

MAC layer

Ethernet and/or IEEE 802.3-2002.

Service multiplexing

Yes or no. If yes, all-to-one bundling must be no.

Bundling

Yes or no. Must be no if all-to-one bundling is yes and yes if all-to-one bundling is no.

All-to-one bundling

Yes or no. If yes, service multiplexing and bundling must be no. Must be no if bundling is yes.

Ingress and egn5ss bandwidth profile per UNI

No or one of the following parameters: CIR, CBS, PIR, MBS.

If no, no bandwidth profile per UNI is set; otherwise, the traffic parameters CIR, CBS, PIR, and MBS need to be set.

Ingress and egress bandwidth profile per EVC

No or one of the following parameters: CIR, CBS, PIR, MBS.

Ingress and egress bandwidth profile per CoS identifier

No or one of the following parameters: CIR, CBS, PIR, MBS.

It o ne of the parametars ¡s ctosen, spe cify th e CoS iieiti^er, Delay value, Jitter value, Loss value.

If no, no bandwidth prooiie per CoS ldentlfie r is set, otherwise, the traffic parameters CIR, CBS, PIR, and MBS need to be set.

Ingress and egress bandwidth profile per destination UNI per EVC

No or one of the following parameters: CIR, CBS, PIR, MBS.

Egress ban dwidth profile pew source UNI per EVC

No of on e of ohe foyow ine parametens: QR, CBSf HR, MBS|

Layer 2 Co ntnol Protoco I pronetsing

Process , discard, or pass to EVC nhd folI owing co ytrol ptoso col sri^mes:

• IEEE 802.3x MAC control

• Link Aggtegati on Control Protocol (LACP)

• IEEE 802.1x port authentication

• Generic Attribute Registration Protocol (GARP)

t stp

, Proto cols multicast to all bridges in a bridged LAN

UNI service activation time

Time value

Was this article helpful?

0 0

Post a comment