Do I Know This Already Quiz

The purpose of the "Do I Know This Already?" quiz is to help you decide whether you really need to read the entire chapter. If you already intend to read the entire chapter, you do not necessarily need to answer these questions now.

The eight-question quiz, derived from the major sections in the "Foundation Topics" portion of the chapter, helps you determine how to spend your limited study time.

Table 8-1 outlines the major topics discussed in this chapter and the "Do I Know This Already?" quiz questions that correspond to those topics.

Table 8-1 Do I Know This Already?" Foundation Topics Section-to-Question Mapping

Foundations Topics Section

Questions Covered in This Section

Navigating Through a Cisco 2950 Switch

2, 6

Switch Initialization

5, 7, 8

Configuring Cisco 2950 IOS Software

1, 3, 4

CAUTION The goal of self-assessment is to gauge your mastery of the topics in this chapter. If you do not know the answer to a question or are only partially sure of the answer, you should mark this question wrong for purposes of the self-assessment. Giving yourself credit for an answer that you correctly guess skews your self-assessment results and might provide you with a false sense of security.

1. In which of the following modes of the CLI could you configure the duplex setting for interface fastethernet 0/5?

a. User mode b. Enable mode c. Global configuration mode d. Setup mode e. Interface configuration mode

2. In which of the following modes of the CLI could you issue a command to erase the initial configuration of the switch?

a. User mode b. Enable mode c. Setup mode d. Global configuration mode e. Interface configuration mode

3. What type of switch memory is used to store the configuration used by the switch when the switch first comes up?

a.

RAM

b.

ROM

c.

Flash

d.

NVRAM

e.

Bubble

4. What command copies the configuration from RAM into NVRAM?

a. copy running-config tftp b. copy tftp running-config c. copy running-config start-up-config d. copy start-up-config running-config e. copy startup-config running-config f. copy running-config startup-config

5. What mode prompts the user for basic configuration information?

a. User mode b. Enable mode c. Global configuration mode d. Setup mode e. Interface configuration mode

6. Imagine that you had configured the enable secret command, followed by the enable password command, from the console. You log out of the switch and log back in at the console. Which command defined the password that you had to type to access privileged mode again from the console?

a. enable password b. enable secret c. Neither enable password nor enable secret d. You cannot configure both enable secret and enable password at the same time.

7. In what LED mode does the switch use the per-port LEDs to show information about the current load on the switch?

8. Which of the following is not true of both a 2950 switch and Cisco routers?

a. Accessible from a console and auxiliary port b. Can enter configuration mode using the configure terminal command c. Expects the enable secret password instead of the enable password if both are configured d. None of the above

The answers to the "Do I Know This Already?" quiz are found in Appendix A, "Answers to the 'Do I Know This Already?' Quizzes and Q&A Sections." The suggested choices for your next step are as follows:

■ 6 or less overall score—Read the entire chapter. This includes the "Foundation Topics" and "Foundation Summary" sections and the Q&A section.

■ 7 or 8 overall score—If you want more review on these topics, skip to the "Foundation Summary" section and then go to the Q&A section. Otherwise, move to the next chapter.

Was this article helpful?

0 0

Post a comment