Cisco Catalyst Switch Show Inline Power Status
Cisca.com
|
show port inline |
power 7 |
|||||
|
Default Inline Power allocation per |
port: |
10.000 Watts |
(0.23 Amps @42V) |
|||
|
Total |
inline power drawn |
by module |
7: 75 |
60 Watts (1.80 |
Amps @42V) |
|
|
Port |
InlinePowered |
PowerAllocated |
||||
|
Admin |
Oper |
Detected |
mWatt |
mA @42V |
||
|
7/1 |
auto |
off |
no |
0 |
0 |
|
|
7/2 |
auto |
on |
yes |
6300 |
150 |
|
|
7/3 |
auto |
on |
yes |
6300 |
150 |
|
|
7/4 |
auto |
off |
no |
0 |
0 |
|
|
7/5 |
auto |
off |
no |
0 |
0 |
|
|
7/6 |
auto |
off |
no |
0 |
0 |
|
|
7/7 |
auto |
off |
no |
0 |
0 |
|
|
show power inline |
||||||
|
Interface |
Admin |
Oper |
Power |
mWatt ) |
Device |
|
|
FastEthernet9/1 |
auto |
on |
6300 |
Cisco 6500 |
IP Phone |
|
|
FastEthernet9/2 |
auto |
on |
6300 |
Cisco 6500 |
IP Phone |
|
|
FastEthernet9/3 |
auto |
off |
0 |
n/a |
||
© 2005 Cisco Systems, Inc. All rights reserved CIPT1 V4.1—2-10
© 2005 Cisco Systems, Inc. All rights reserved CIPT1 V4.1—2-10
Use the command shown in the figure to display a view of the power allocated on Cisco Catalyst switches. The switch shows the default allocated power as 10 W in addition to the inline power status of every port. The "Inline Power Syntax Descriptions" table provides a brief description of the syntax output.
Inline Power Syntax Descriptions
|
Column Heading |
Description |
|
Port |
Identifies the port number on the module |
|
Inline Powered |
|
|
Admin |
Identifies the port configuration from using the set inlinepower mod/port [auto | off] command |
|
Oper |
Identifies whether the inline power is operational |
|
Power Allocated |
|
|
Detected |
Identifies whether power is detected |
|
mWatt |
Identifies the milliwatts supplied on a given port |
|
mA @42V |
Identifies the milliamps at 42 V supplied on a given port (the actual voltage is -48 V) |
Continue reading here: Verifying Voice VLAN Configuration Using Cisco CatOS
Was this article helpful?