Example 164 Testing MST and RSTP

surgery#ping Protocol [ip]:

Target IP address: Repeat count [5]: 10000 Datagram size [100]: Timeout in seconds [2] : Extended commands [n]: Sweep range of sizes [n]: Type escape sequence to abort.

Sending 10000, 100-byte ICMP Echos to, timeout is 2 seconds: !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

! . . ! <—Gig 0/2 dropped !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Success rate is 99 percent (9998/10000), round-trip min/avg/max = 1/2/20 ms surgery#

In the next two steps, you configure SVIs and enable routing on the walkerl switch. You need four SVIs—one for each VLAN and one for the management VLAN. One SVI, interface VLAN 192, is neec for the management VLAN. You also need three more SVIs: interface VLAN 20 for the admin, and interface VLAN 100 and interface VLAN 300 for the routers. Qxample 1-65 shows the necessary configuration of the walkerl switch.

Was this article helpful?

0 0

Post a comment