Example 133 Configuring a Routed Port

3550_switch(config)#interface fast 0/7 3550_switch(config-if)#no switchport

02:06:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/7, changed 02:06:23: %LINK-3-UPDOWN: Interface FastEthernet0/7, changed state to down

02:06:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/7, changed 3550_switch(config-if)#ip address 172.16.200.16 255.255.255.0

3550_switch(config-if)#interface fast 0/8 3550_switch(config-if)#no switchport 3550_switch(config-if)#

02:06:53: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/8, changed 02:06:23: %LINK-3-UPDOWN: Interface FastEthernet0/8, changed state to down 02:06:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/8, changed 3550_switch(config-if)#ip address 172.16.201.16 255.255.255.0

3550_switch(config-if) #AZ 3550_switch

3550_switch#show vlan internal usage

VLAN Usage

1025 FastEthernet0/7

! Internal VLANs used

1026 FastEthernet0/8

If you switch a port/interface from a switch port to a routed port by using the no switchport interf com mand, and y ou w ant to change t fie interfaee back to a swieched in terface , you mbst ente r the i comman duwi┬░chport witlnout subcomma nds.

0 0

Post a comment