RIPv2 Configuration 9 Points

Configure RIPv2 on Router R4 only.

■ Backbone segment 2 is running RIPv2 for networks

■ Backbone segment 2 is running RIPv2 only. There is no RIPv2 password. You should be seeing routes of the form from BB2.

■ Redistribute the odd RIP routes into the IGP network from backbone segment 2.

■ Make sure that you can see distributed RIP routes throughout your topology and that the OSPF cost metric is set to 1000 for all RIP routes redistributed.

■ Use a route map named riptoospf to set the OSPF cost.

■ Use the least number of Cisco IOS commands wherever possible.

Was this article helpful?

0 0

Post a comment