OSPF Configuration 8 Points

Configure OSPF as follows; do not create any nonspecified OSPF areas:

■ Configure the OSPF backbone over the Frame Relay network between Routers R1, R2, and R3.

■ The ISDN link between R2 and R3 resides in the area

■ The link between R1 and R2 resides in area 4 (note that this VLAN also runs EIGRP).

■ The loopbacks on R1, R2, and R3 can reside in the most appropriate area. Do not configure any network in area 0 unless required.

■ Make sure all OSPF routes are redistributed and reachable in the RIPv2 and EIGRP domains.

■ Ensure that the OSPF backbone in the Frame Relay cloud is authenticated.

■ Ensure that R1 or R2 is the designated router (DR) on all segments.

■ Ensure that the router ID of all OSPF-enabled routers is the loopback address.

■ Do not create any additional areas.

■ Set the hello interval between links R1 and R2 to 20 seconds.

■ Set the hello interval on the R3 Ethernet segment to 20 seconds.

■ Ensure that all loopbacks appear as /24-bit networks on all IP routing tables. Do not use the redistribute connected command on any router to accomplish this.

■ Ensure that any rogue devices running multicast OSPF do not impact any router resources.

Was this article helpful?

0 0

Post a comment