Frame Relay Setup 05 Hour

Configure IP across your Frame Relay network, as displayed in Figure C-2.

■ You have to use static maps for each protocol. No dynamic mapping is permitted.

■ No subinterfaces are allowed on any router.

■ Use the most efficient subnetwork for IP addresses on the Frame Relay cloud.

■ You can assign a subnet from your Class B range.

■ Use LMI-type Cisco only and do not rely on auto-sensing the LMI type on any routers. All router interface types are DTE. The Frame Relay port type is DCE.

■ Do not use the keyword broadcast for the Frame Relay link between R6 and R7 when mapping IP.

■ Make sure you can also ping the local interface from each router configured for Frame Relay.

Was this article helpful?

0 0

Post a comment