Communications Server 025 Hour

NOTE Not all CCIE R&S labs require you to configure a communication server.

Configure the communication server so that when you type the host name of a router on the server, you are connected across the console port to that router. Set up the routers in Figure C-1 with the following physical attributes:

■ Configure R1 as the communication server with the ip host command.

■ Communication server ports 2 to 8 are connected to Routers R2 to R8, respectively.

■ Communication server port 9 connects to the Catalyst Ethernet switch.

■ R9 is a Catalyst 6509 switch with a Multilayer Switch Feature Card (MSFC) module installed.

Was this article helpful?

0 0

Post a comment