Catalyst Ethernet Switch Setup I 0 Points

Configure the Ethernet switch for three VLANs.

■ VLAN 2 named VLAN_A is connected to R1, R2, and backbone segment 1.

■ VLAN 4 named VLAN_C is connected to R4 and backbone segment 2.

■ VLAN D and E are preconfigured.

Using VLAN_A, configure the management interface sc0 with the address Ensure that all devices in your network can Telnet to the switch even if R1 or R2 is down. (Note that you may need to configure an additional IP address to accomplish this task.)

Make sure the switch is configured in the VTP domain Cisc01_vTp and that the switch can create and delete VLANs in the future.

IP Configuration and IP Addressing (0 Points) 661

Was this article helpful?

0 0

Post a comment