Basic IBGP Configuration 4 Points

Configure IBGP on Routers R1, R2, and R3 in your network (use AS 333):

■ Do not use any WAN IP interfaces for IBGP sessions, because your network is prone to failures across the Frame Relay cloud.

■ Configure R3 as route reflector.

■ Minimize IBGP configurations as much as possible.

■ Do not disable BGP synchronization.

■ As long as there is IP connectivity in your network, ensure that BGP is active in all routers.

■ Using the network command only, advertise all networks to route reflector R3.

■ Do not change the administrative distance on any interior routing protocol.

■ Make sure you have full BGP connectivity.

■ Be sure all routers have entries in their IP routing tables.

Was this article helpful?

0 0

Post a comment