Backup Delay

Cisco.com j _y128 kpbs

256 kbps backup delay {enable-delay | never} {disable-delay | never}

By default the secondary interface is immediately brought on primary link failure.

© 2001, Cisco Systems, Inc. All rights reserved.

Cisco CCIE Prep vl.O—Module 3-54

You can configure a value that defines how much time should elapse before a secondary line status changes after a primary line status change. This means that you can define two delays:

■ A delay that specifies the amount of time after the primary line goes down, but before the secondary line is activated

■ A delay that specifies the amount of time after the primary line comes up, but before the secondary line is deactivated

Was this article helpful?

0 0

Post a comment