The CPE can use a static default route to reach all remote destinations

© 2004 Cisco Systems, Inc. All rights reserved. BCRAN v2.1-4-10

Configure a static default route on the Cisco 827 router to allow the router to reach all unknown destinations toward the dialer interface. In most DSL installations, the CPE will not be running a dynamic routing protocol to the aggregation router of the service provider. Therefore, a static default route is required on the Cisco 827 router.

When the PPPoE session has been established between the Cisco 827 router and the aggregation router of the service provider, the dialer interface IP address is assigned from the service provider aggregation router via IPCP. The service provider aggregation route will automatically build a host route to reach the Cisco 827 router-dialer interface.

0 0

Post a comment