PPP on BRI Monitoring

Ctfcocam

KTU L5Q[> bybt-is. E'rT €1 Kbit, ELY 290GB uettu, ctuy £55/255. lcail 1/25S R^e^siHi«1«fr ppp,. " -ic^Ti^ifc r.e-t lc«p«liv« (10 8«}

Last iiiTrjLt W: SO 02. cmtpiit CQ:C€:0£". output huq nm:

1-a.et oloari^ç r,r -chow lnt«rTpocM cw^rarc -wvosr

¡Input. -iuOu-LS : Ö/"75/0 iöJ. at/Cfjaji/dLi > .■ fQtal OuLj>uC 1¿<¡¿0 0

Cutpruk. ^liAuh i a/3. ÜfJÜ f üd /Ü (.n ulb .4. I.uijal /lJ^r-HnlKii:l,''Jj.ii|j:i)

RA3PTW-1 CSW^PFflB Uma Q/f. ^fll lflfl«ITfl!!/BBT A". lARAhAfIJi fl KiüutA output: rsif-fl Q titn/fidcr i) p4ifücnt.n/Hn •IU îxipgt. 14 tyt«, J T43 tyt'ier

OK hr.uAnu , CI1 r.ir.t.it, D ■rri-AJitTJ.. Q M^snhTlnji 0 Input erroro,■ 0 CKC, 0 Trame, C ovorron, -5 ignored. 0 ¿tort outputr 4 l^ltrtr 0 undu££u:t Q iwifrpr.F flPPflra, il ¿■.■llifl.liHkR r fi In^PT^ra™» pps»ft"a Q OuLpkL SbuËIwj; rüiiuiwS, 0 vvlptl buritiie fH4Pfftil iul 3 rcirri-HF t: run nit tor n

© 2004 Cisco Systems, Inc. All rights reserved. BCRAN v2.1—6-7

After you have configured for ISDN connectivity, you can check the interface to see evidence of your configuration and some of the resulting call setup details. If your router acts as a TE1 (has a native BRI), use the show interfaces bri EXEC command to monitor the interface and optionally, the individual B channels for the BRI interface.

The command displays information on the encapsulation and channel status for LCP and Network Control Protocol (NCP), including the protocols that can transmit over the link. The figure displays output for the first B channel of the BRI. It shows that the interface is configured for PPP encapsulation, that LCP is Open (currently active), and that NCP is Open and has negotiated the protocols IP and Cisco Discovery Protocol (CDP) on the link.

0 0

Post a comment