Examples

This topic describes examples of troubleshooting when dialing does not occur.

Examples

* No dialer-group configured on the dialer interface

No dialer-group defined

* Dialer-list does not exist

dialer-list 1 not defined

* No physical interface available to make the call

No free dialer

* No dialer-string configured on the dialer interface

Cannot place call, no dialer string set

© 2004 Cisco Systems, Inc. All rights reserved. BCRAN v2.1-

—7-6

Another scenario occurs when there is debug output, but there is no "Attempting to Dial" message generated. In this case, there is probably an IP packet routed to the interface, but the router discards it and does not initiate the call for some reason. Look at the debug dialer output to find out why the call attempt is not made.

The following are examples of output generated by the debug dialer command. The examples focus on specific problems followed by possible solutions.

0 0

Post a comment