Configuring the Default Metric

The default metric can be configured in several ways. The first is to include the metric in the redistribute command, as shown in the preceding command syntax and as illustrated in Example 10-1.

Example 10-1 Including the Metric in the redistribute Command router eigrp 100

redistribute rip metric 10000 100 255 1 1500 network 140.100.0.0 passive interface e1

This configuration shows the following:

• The use of the redistribute command

• The routing process from which the routes are being accepted

• The metric parameter, allowing the configuration of the EIGRP to state the new metric that the old RIP networks will use while traversing the EIGRP network

Was this article helpful?

0 0

Post a comment